Black Hydro Easy

Multipurpose bituminous liquid thixotropic waterproofer composed of inert fillers, elastomeric resins and additives. Suitable for waterproofing foundation walls against the ground. For sealing and finishing in roof waterproofing and for bonding insulation panels.

Good elasticity | Cold installation | Solvent-free.

Consumption: from 1.2 to 1.8 kg/m²/mm.

Instructions for use

Instructions for use
Mix before use; the product can be applied by roller, brush, spray, long-handed scrubbing brush, trowel or toothed trowel; best applied in two coats. For an easy application on large surfaces, dilution with water is recommended up to maximum 10%. Apply a second wet-on-wet coat if the first one has been reinforced (using non-woven fabric Tessuto NT50), otherwise wait until the first coat is completely dry (24-48 hours), depending on the environmental conditions and the substrate porosity. Clean the tools with water after use and, if the product has dried, remove it with hot water or with the most commonly available synthetic thinners.

Storage

Sensitive to frost, do not expose the packages to temperatures below + 5 °C; once frozen the product can no longer be recovered. It will keep for at least 12 months in its original packaging.

Warnings

• Apply the product at an ambient temperature not lower than +5 °C, when fog, rain and frost conditions are not expected to occur, avoiding extreme temperatures.
• Avoid applying the product on new bituminous surfaces, freshly applied, which could release hydrocarbons and cause problems of film adherence on the sheath.
• Do not exceed the recommended quantity for each coat so as not to hinder the evaporation of water contained in the bituminous liquid product, which would otherwise remain trapped under the dried film.
• On surfaces larger than 10 m² or stressed substrates we recommend reinforcing with suitable reinforcing Tessuto NT50 polyester non-woven fabric buried in the first coat while still wet.
• Temperatures higher than 35 °C impair the workability of the product due to a too fast drying of the film on the surface.
• Foundations waterproofed with Black Hydro Easy must be further covered with a suitable protection, to prevent the sheath from being cut during backfilling operations.
• The waterproofer may be walked on occasionally in cases of maintenance activities.
• Do not use on surfaces subject to rising or high water pressure.